When I ordered the transmission mount the kick panels, window cranks and battery hold down were also ordered to finish the interior trim and the upcoming new battery. Next on the agenda was to finish the exhaust system and a 2" exhaust pipe kit and flanges were bought. The cut out shown has been pie cut and re-welded to raise it a couple of inches. The re-worked cut out assemble. I had to remove the mufflers that came with the car as they were just too long to fit in the space in front of the rear axle. A pair of 18" Tubo mufflers took their place that fit in the space under the rear seat floor pan. The 40" straight pipes were tack welded to in place alongside the drive shaft. Then to make sure that the cut outs did not hit the floor they got bolted in place. Next the mufflers were fitted in place, new supports fabricated, and the flanges welded on. Fitting the tail pipes was done by using a combination of the 90, 45 and straight pipes from the kit. the 45 bends had to ...