The car is still on the rotisserie getting the grease, oil, under seal & old paint cleaned off. I have a couple more passes to be made before it ready for paint. I can only scrub on the bottom for an hour each time and clean and repair other parts for the rest of my workday. Took the heater out and apart to be repaired as extra parts for it came with the car, new heater core behind the old one. The box is fiberglass, but the internal parts and doors are rusty steel. The packages in the background are new gaskets and seals that came as spare parts. The emergency brake unit, cable and parts were bead blasted and painted. The handle was broken off and will be replaced. All the metal parts of the heater were bead blasted, painted then put back together using the new core and gaskets. The rear fender apron was rusted through and needed repair. With the rusted part cut out a new panel was made. New panel welded in place ready for a coat of paint. Leaf springs and fuel line were sand...

Started to take the car apart for cleanup and prep for paint. In this picture the front fenders, side glass & regulators, rear end and interior have been removed with one of the rotisserie units bolted to the front frame.  Hoisted the back of the car with the overhead hoist and put jack stands under it so I could work under the car. The gas tank came right out and is in good condition and will be reused. With the rear end removed it should have been easy to remove the leaf springs, the driver side came right out, the left one front bolt was frozen in the spring, and I tried a hydraulic press, penetrating oil, and heat then ended up having to cut the bolt out with a cut off wheel. You can see a rusted-out place on the passenger side Inner fender that will be repaired.  Once on the rotisserie it was turned up on its side and pressured washed. I used a degreaser product and dawn soap mix to scrub down the bottom then pressure washed it again. The dirt and road grime came off,...